The exact times vary by area and are indicated by signs at the roadside, or by Controlled Parking Zone entry signs. In the United Kingdom, the Isle of Man and Ireland, It indicates that parking or waiting at that roadside is prohibited at certain times of day. The lines are spaced 100mm apart.Main article: Parking restrictions in the United KingdomĪ single yellow line is a road marking that is present on the side of the carriageway across the British Isles. There may be two lines present, for example, two parallel solid yellow lines or a solid yellow line and a broken white line. Yes, you can turn right across a yellow no-passing line, but bear in mind that they are painted where visibility is poor, so take care. Can you cross a yellow no-passing line to turn into a driveway? So, as long as it’s safe to do so, you can cross over that yellow centre line to get by another vehicle that’s parked. Can you cross a yellow no-passing line to pass a parked car?Ĭlause 2.3(3) in the Land Transport (Road User) Rule 2004 says that you can cross the no-passing line if it’s impractical not to do so because of the size of your vehicle or load, or the other vehicle is creating an obstruction. The minimum length of a no-overtaking line is 80m on rural roads. On urban roads, the length of restricted visibility must exceed 30m and the minimum length of the line is 30m. The markings start either 80m before the area of reduced visibility (if it is longer than 160m) or from 80m back from where the motorist would regain normal visibility. These lines are often used on rural where there is restricted visibility less than 330m ahead and the distance of the restriction extends more than 80m on. You may still overtake another vehicle, as long as you can keep your wheels to the left of the yellow line. Solid yellow lines, also called no-overtaking lines, indicate that there is restricted visibility or another danger. Motorists must not cross a solid yellow line. On an urban road, 3 stripes are given before a solid yellow line is painted.īroken yellow lines are also used on the edge of the road to indicate no parking/stopping. On rural roads, 5 stripes are given before a solid yellow line is painted. The stripe width is 100mm and its length is 13m with a 7m gap. Broken yellow lines begin in the distance for the left lane
#DOUBLE SOLID WHITE LINE DRIVERS#
To drivers who are following another vehicle, they indicate that now is not the right time to overtake as a solid yellow line is coming up.
They are also called no-overtaking advance warning lines and they indicate to drivers who are overtaking that they should move back to the left. Dashed or broken yellow lineīroken yellow lines are painted just before a solid yellow line. Solid white lines are also used to mark the edge of the road. There are some exceptions to this in section 2.7 of the Land Transport (Road User) Rule 2004.
#DOUBLE SOLID WHITE LINE CODE#
The Road Code says you are not permitted to overtake at an intersection. Intersections are sometimes marked with a solid white line. Coming up to a one-lane bridge, the centre line is solid to warn of the danger The road is narrow but it’s not appropriate for a solid yellow line as traffic volumes are light (it’s on Waiheke Island) and visibility isn’t unduly compromised. You are allowed to cross a solid white line, but you should take extra care as the line is there as a warning. Intersection at Queen St, Auckland, showing solid white lines extending 15m back from the intersection Solid centre lines before curves usually extend for 30-50m whereas before intersections they usually extend for 15m. Solid white centre line due to increased risks (speed control, cycle route) the road is narrow or has restricted visibility) or there is a hazard ahead such as a pedestrian crossing, an intersection or a sharp curve. Solid white centre lineĪ solid white line has the same legal standing as a dashed white line, but it warns motorists that conditions might be more challenging (e.g. Where markings indicate that a raised traffic island or median is about to start, they are 150mm wide. Short dashed lines mark the turning bay to the right Where the lines are used to show one lane splitting into two, such as where a passing lane starts, the line length is 1m and the gap is 1m until the lane is fully formed. On standard roads these lines are 100mm wide, 3m long and have a 7m gap between them.
Rural road showing a broken white centre line and a solid white edge line A dashed or broken white line indicates lanes of a road where there are no overtaking restrictions and the road is not considered to have any unusual or dangerous features.
0 kommentar(er)
